Removal [10/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE ENGINE UNDER COVER
Refer to PROCEDURE - Step 10 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 10 [09/2020 - ]
REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 1 [10/2016 - 09/2020] , or refer to PROCEDURE - Step 1 [09/2020 - ]
REMOVE INLET NO. 1 AIR CLEANER
Refer to PROCEDURE - Step 18 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 18 [09/2020 - ]
REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
Refer to REMOVAL [10/2017 - ]

SET NO. 1 CYLINDER TO TDC/COMPRESSION

Turn the crankshaft clockwise to align the timing mark (cutout) on the crankshaft pulley with the "0" timing mark on the timing chain cover assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	"0" Timing Mark
*b	Timing Mark (Cutout)

Check that the protrusion on the inside of the camshaft timing gear assembly is at the top.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Protrusion

HINT:

If the protrusion is not at the top, rotate the crankshaft clockwise 360° and align the timing marks again.

REMOVE CAMSHAFT TIMING GEAR BOLT

Using SST, hold the crankshaft pulley.

SST: 09213-54015
1. 91651-60855
SST: 09330-00021

Remove the camshaft timing gear bolt.

NOTE:

If the camshaft timing gear bolt has been struck or dropped, replace it.