LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine Control System (2GR-FKS) - Service Information) >> Accelerator Pedal >> On-Vehicle Inspection [10/2017 - ] >> Procedure

On-Vehicle Inspection [10/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.

      Powertrain > Engine > Data List 

      Tester Display
      Accelerator Position Sensor No. 1 Voltage
      Accelerator Position Sensor No. 2 Voltage
    5. Read the values displayed on the Techstream.

      Standard Voltage

      Techstream Display Condition Specified Condition
      Accelerator Position Sensor No. 1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
      Accelerator pedal fully depressed 2.6 to 4.5 V
      Accelerator Position Sensor No. 2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
      Accelerator pedal fully depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

scientia non olet · About LEMON Manuals