DTC P0630-51: VIN Not Programmed [08/2015 - 09/2022]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630-51)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
NOTE:If P0630-51 is output, the VIN must be written to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is written. If DTCs other than P0630-51 are output, troubleshoot them first.
Result
Result Proceed to DTC P0630-51 is output A DTC P0630-51 and other DTCs are output B
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 10/2016] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2016 - 10/2017] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2017 - 09/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2018 - 09/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2019 - 09/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2020 - 11/2021] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 09/2022]
Result:
A
See step 2
- INPUT VIN
- Input the VIN.
Refer to REGISTRATION [08/2015 - ]
Result
Proceed to NEXT
Result:
NEXT
END
- Input the VIN.