Hazard Warning Switch Circuit [04/2013 - 10/2016]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the display on the Techstream.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch signal	ON or OFF	ON: Hazard warning signal switch on OFF: Hazard warning signal switch off	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Hazard Flasher Switch

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [04/2013 - 06/2014]  , or refer to  PROBLEM SYMPTOMS TABLE [06/2014 - 08/2015]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2015 - 10/2016] 

Result: 

NG 

See step  2

1. Remove the air conditioner control assembly (hazard warning signal switch).

   Refer to REMOVAL [04/2013 - ]

2. Inspect the air conditioner control assembly (hazard warning signal switch).

   Refer to INSPECTION [04/2013 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE AIR CONDITIONER CONTROL ASSEMBLY (HAZARD WARNING SIGNAL SWITCH). Refer to  REMOVAL [04/2013 - ] 

Result: 

OK 

See step  3

1. Disconnect the K4 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K65-11 (LJB) - K4-12 (HAZM)	Always	Below 1 Ω
   K65-11 (LJB) - Body ground	Always	10 kΩ or higher
   K65-9 (HAZ) - K4-11 (HZSW)	Always	Below 1 Ω
   K65-9 (HAZ) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2013 - 10/2016] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR