DTC P007A-15: Charge Air Cooler Temperature Sensor Bank 1 Circuit Short to Battery or Open [08/2015 - 09/2022]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.

READ VALUE USING TECHSTREAM (CHECK FOR OPEN IN WIRE HARNESS)

Disconnect the No. 1 turbo pressure sensor connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 1 Turbo Pressure Sensor	*2	ECM
*a	Front view of wire harness connector (to No. 1 Turbo Pressure Sensor)	-	-

Connect terminals 4 (THIM) and 2 (E2) of the No. 1 turbo pressure sensor connector on the wire harness side.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.

Enter the following menus: Powertrain / Engine / Data List / Intake Air Temperature B1S1 (Turbo).

Powertrain > Engine > Data List

Tester Display
Intake Air Temperature B1S1 (Turbo)

According to the display on the Techstream, read the Data List.

Standard value

140°C (284°F)

Result

Proceed to
OK
NG

Result:

REPLACE NO. 1 TURBO PRESSURE SENSOR. Refer to PROCEDURE - Step 1

Result:

See step 2

CHECK HARNESS AND CONNECTOR (NO. 1 TURBO PRESSURE SENSOR - ECM)

Disconnect the No. 1 turbo pressure sensor connector.
Disconnect the ECM connector.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
F100-4 (THIM) - F78-107 (THIM)	Always	Below 1 Ω
F100-2 (E2) - F78-137 (EPIM)	Always	Below 1 Ω
F100-4 (THIM) or F78-107 (THIM) - Other terminals	Always	10 kΩ or higher

Result

Proceed to
OK
NG

Result:

REPLACE ECM. Refer to REMOVAL [08/2015 - ]

Result:

REPAIR OR REPLACE HARNESS OR CONNECTOR