LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Engine Control System (8AR-FTS) - Diagnostic Codes (01 Of 14)) >> SFI System >> DTC P0013-13: Camshaft Position "B" - Actuator Bank 1 Circuit Open [08/2015 - 09/2022] >> Procedure

DTC P0013-13: Camshaft Position "B" - Actuator Bank 1 Circuit Open [08/2015 - 09/2022]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ OUTPUT DTC (DTC P0013-13) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTC after recording the freeze frame data and DTC.

      Powertrain > Engine > Clear DTCs 

    5. Turn the engine switch off and wait for at least 30 seconds.
    6. Start the engine.
    7. Turn the Techstream on.
    8. Enter the following menus: Powertrain / Engine / Trouble Codes.
    9. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTC P0013-13 is output A
      DTCs are not output B

    Result: 

    B 

    CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [08/2015 - ] 

    Result: 

    A 

    See step  2

  2. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR EXHAUST CAMSHAFT) 
    1. Inspect the camshaft timing oil control valve assembly (for exhaust camshaft).

      Refer to INSPECTION [08/2015 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR EXHAUST CAMSHAFT). Refer to  REMOVAL [08/2015 - ] 

    Result: 

    OK 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR EXHAUST CAMSHAFT) - ECM) 
    1. Disconnect the camshaft timing oil control valve assembly (for exhaust camshaft) connector.
    2. Disconnect the ECM connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F88-2 - F78-38 (OE1+) Always Below 1 Ω
      F88-1 - F78-68 (OE1-) Always Below 1 Ω
      F88-2 or F78-38 (OE1+) - Body ground and other terminals Always 10 kΩ or higher
      F88-1 or F78-68 (OE1-) - Body ground and other terminals Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE ECM. Refer to  REMOVAL [08/2015 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals