DTC P0010-13: A Camshaft Position Actuator Bank 1 Circuit Open; DTC P0020-13: Camshaft Position "A" Actuator Bank 2 Circuit Open [10/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTC.
Powertrain > Engine > Clear DTCs
- Turn the engine switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 2
- READ OUTPUT DTC (DTC P0010-13 OR P0020-13)
- Connect the Techstream to the DLC3.
- Start the engine.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0010-13 or P0020-13 is output A DTCs are not output B
Result:
B
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [10/2017 - ]
Result:
A
See step 3
- INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (FOR INTAKE CAMSHAFT)
- Inspect the cam timing oil control solenoid assembly (for intake camshaft).
Refer to INSPECTION [10/2017 - ]
Result
Proceed to OK NG
Result:
NG
REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (FOR INTAKE CAMSHAFT). Refer to REMOVAL [10/2017 - ]
Result:
OK
See step 4
- Inspect the cam timing oil control solenoid assembly (for intake camshaft).
- CHECK HARNESS AND CONNECTOR (CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (FOR INTAKE CAMSHAFT) - ECM)
- Disconnect the cam timing oil control solenoid assembly (for intake camshaft) connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F108-1 - F102-38 (OC1+) Always Below 1 Ω F108-2 - F102-68 (OC1-) Always Below 1 Ω F107-1 - F102-9 (OC2+) Always Below 1 Ω F107-2 - F102-8 (OC2-) Always Below 1 Ω F108-1 or F102-38 (OC1+) - Body ground and other terminals Always 10 kΩ or higher F108-2 or F102-68 (OC1-) - Body ground and other terminals Always 10 kΩ or higher F107-1 or F102-9 (OC2+) - Body ground and other terminals Always 10 kΩ or higher F107-2 or F102-8 (OC2-) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2017 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR