LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Automatic Transmission System (A960E) - Diagnostic Codes (1 Of 2)) >> Automatic Transmission System >> DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [04/2013 - 08/2015] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Warm up the engine.
    2. Turn the engine switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the engine switch on (IG).
    5. Turn the Techstream on.
    6. Enter the following menus: Powertrain / Engine and ECT / Data List / Neutral Position Switch Signal, Shift SW Status (P Range), Shift SW Status (R Range), Shift SW Status (N Range), Sports Shift Up SW, Sports Shift Down SW, Sports Mode Selection SW, Shift SW Status (D Range).
    7. According to the display on the Techstream, read the "Data List".

      Powertrain > Engine > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Neutral Position SW Signal PNP switch status ON or OFF
      • ON: Shift lever in P or N
      • OFF: Shift lever not in P or N
      When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch assembly or shift cable may be incorrect.
      Shift SW Status (P Range) PNP switch status ON or OFF
      • ON: Shift lever in P
      • OFF: Shift lever not in P
      When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch assembly or shift cable may be incorrect.
      Shift SW Status (R Range) PNP switch status ON or OFF
      • ON: Shift lever in R
      • OFF: Shift lever not in R
      When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch assembly or shift cable may be incorrect.
      Shift SW Status (N Range) PNP switch status ON or OFF
      • ON: Shift lever in N
      • OFF: Shift lever not in N
      When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch assembly or shift cable may be incorrect.
      Sports Shift Up SW Sport shift up switch status ON or OFF Shift Lever
      • ON: Shift lever held in "+" (up-shift)
      • OFF: Shift lever not held in "+" (up-shift)

      Shift Paddle Switch
      • ON: "+" shift paddle operated and held (up-shift)
      • OFF: "+" shift paddle not operated (up-shift)
      -
      Sports Shift Down SW Sport shift down switch status ON or OFF Shift Lever
      • ON: Shift lever held in "-" (down-shift)
      • OFF: Shift lever not held in "-" (down-shift)

      Shift Paddle Switch
      • ON: "-" shift paddle operated and held (down-shift)
      • OFF: "-" shift paddle not operated (down-shift)
      -
      Sports Mode Selection SW Sport mode select switch status ON or OFF
      • ON: Shift lever in M, "+" or "-"
      • OFF: Shift lever not in M, "+" or "-"
      -
      Shift SW Status (D Range) PNP switch status ON or OFF
      • ON: Shift lever in D, M, "+" or "-"
      • OFF: Shift lever not in D, M, "+" or "-"
      When the shift lever position displayed on the Techstream differs from the actual position, the adjustment of the park/neutral position switch assembly or shift cable may be incorrect.

      Powertrain > Engine > Data List 

      Tester Display
      Neutral Position SW Signal
      Shift SW Status (P Range)
      Shift SW Status (R Range)
      Shift SW Status (N Range)
      Sports Shift Up SW
      Sports Shift Down SW
      Sports Mode Selection SW
      Shift SW Status (D Range)