DTC P0617: Starter Relay Circuit High [06/2014 - 08/2015]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Starter Signal.

   Powertrain > Engine > Data List 

   Tester Display
   Starter Signal

5. Check the value displayed on the Techstream when the vehicle is driven at 20 km/h (12.43 mph) or more.
   WARNING:

   When performing the confirmation driving pattern, obey all speed limits and traffic laws.

   Result

   Condition	Techstream Display	Proceed to
   Driving at 20 km/h (12.43 mph) or more	OFF	A
   	ON	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [04/2013 - 08/2015] 

Result: 

B 

See step  2

1. Inspect the park/neutral position switch assembly.

   for AWD models: Refer to INSPECTION [04/2013 - ]

   for 2WD models: Refer to INSPECTION [04/2013 - 08/2015]

   Result

   Result	Proceed to
   OK	A
   NG (for AWD models)	B
   NG (for 2WD models)	C

Result: 

B 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY. Refer to  REMOVAL [04/2013 - 08/2015] 

Result: 

C 

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY. Refer to  REMOVAL [04/2013 - 08/2015] 

Result: 

A 

See step  3

1. Repair or replace harness or connector (park/neutral position switch assembly - ST relay - ECM - certification ECU (smart key ECU assembly)).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [04/2013 - 08/2015]

   Powertrain > Engine > Clear DTCs 

5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
7. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0617 is output	A
   DTC is not output	B

Result: 

B 

END 

Result: 

A 

See step  5

1. Check the smart access system with push-button start (for start function).

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [04/2013 - 08/2015]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [04/2013 - 08/2015] 

Result: 

NG 

REPAIR OR REPLACE SMART ACCESS SYSTEM WITH PUSH-BUTTON START. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2013 - 08/2015]