On-Vehicle Inspection [10/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- FUEL PUMP ASSEMBLY OPERATION
- Check fuel pressure.
- Connect the GTS to the DLC3.
- Start the engine.
- Turn the GTS on.
- Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset.
Powertrain > Engine > Active Test
Active Test Display Control the Target Fuel Pressure Offset Data List Display Fuel Pressure (High) - Select the Data List item: Fuel Pressure (High)
- Check that the fuel pressure fluctuates when the target fuel pressure changes.
HINT:
The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.
If the result is not as specified, replace the fuel pump assembly or fuel pressure sensor (fuel delivery pipe with sensor assembly LH).
- Check operating sound.
- Remove the V-bank cover sub-assembly.
Refer to PROCEDURE - Step 3 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 3 [09/2020 - ]
- Start the engine.
- Using a sound scope, check the operating sound of the fuel pump assembly.
If no sound can be heard, check the fuel pump assembly, wire harness and ECM.
- Stop the engine.
- Install the V-bank cover sub-assembly.
Refer to PROCEDURE - Step 104 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 104 [09/2020 - ]
- Remove the V-bank cover sub-assembly.
- Check fuel pressure.