Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE REAR OIL SEAL

Clean the crankshaft and engine rear oil seal retainer.
Apply MP grease to the lip of a new engine rear oil seal.
NOTE:
- Keep the lip free of foreign matter.
- Do not allow MP grease to contact the dust seal section.

Using SST and a hammer, tap in the engine rear oil seal until its surface is flush with the engine rear oil seal retainer edge.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Standard depth

SST: 09223-1503009950-70010
1. 09951-07150

Standard depth

-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

NOTE:

Wipe off extra grease on the crankshaft.
Keep the lip free of foreign matter.
Do not tap in the engine rear oil seal at an angle.
Do not tap in the engine rear oil seal more than necessary.
Do not deform the engine rear oil seal.

INSTALL DRIVE PLATE

Using SST, hold the crankshaft pulley.
- SST: 09330-0002109213-70011
  1. 09213-70020
Clean the 8 bolts and 8 bolt holes.

Install the front drive plate spacer.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Pin Hole
*2	Pin

HINT:

Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

Install the drive plate and rear drive plate spacer onto the crankshaft.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Drive Plate and Ring Gear Sub-assembly
*2	Rear Drive Plate Spacer
	Transmission Side

HINT:

Make sure the installation direction of the drive plate and ring gear sub-assembly and rear drive plate spacer.

Apply a few drops of adhesive to 2 or 3 threads of the 8 bolt tips.

Adhesive

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

NOTE:

Install the bolt within 3 minutes after applying adhesive.

In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.

Fig 1: Drive Plate Bolts Tightening Sequence
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 83.5 N.m (851 kgf/cm, 62 ft.lbf)

NOTE:
Do not start the engine for at least an hour after installing the drive plate.

INSPECT DRIVE PLATE (for 2WD)
Refer to PROCEDURE - Step 2
INSPECT DRIVE PLATE (for AWD)
Refer to PROCEDURE - Step 2
INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (for AWD)
Refer to INSTALLATION [04/2013 - 08/2015]
INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)
Refer to INSTALLATION [04/2013 - 08/2015]
INSPECT FOR OIL LEAK