Installation [10/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus IS 350, 2024 Lexus IS 300, 2023 Lexus IS 350, 2023 Lexus IS 300, and 2022 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

NOTE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

*a	Adhesive 1324
*b	Oil Inlet Port

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque: 15 N.m (153 kgf/cm, 11 ft.lbf)

NOTE:
Do not start the engine for at least 1 hour after installation.
Connect the engine oil pressure switch connector.

ADD ENGINE OIL
See step 7 [10/2017 - 11/2021], or see step 7 [11/2021 - ]
INSPECT FOR OIL LEAK
See step 8 [10/2017 - 11/2021], or see step 8 [11/2021 - ]
INSPECT ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [10/2017 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]
INSTALL NO. 1 AIR CLEANER INLET
Refer to PROCEDURE - Step 75 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 75 [09/2020 - ]
INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 105 [10/2017 - 09/2020] , or refer to PROCEDURE - Step 105 [09/2020 - ]