LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Automatic Transmission System (A960E) - Service Information) >> Shift Paddle Switch >> Inspection [04/2013 - 08/2015] >> Procedure

Inspection [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY466178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Shift Paddle Switch [Transmission Shift Switch Assembly] LH)

      Standard Resistance

      SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) LH:

      Tester Connection Switch Condition Specified Condition
      2 (ECC) - 1 (SDN) "-" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher

      If the resistance values are not as specified, replace the shift paddle switch (transmission shift switch assembly) LH.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) RH:

      Tester Connection Switch Condition Specified Condition
      3 (SUP) - 2 (ECC) "+" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher
      GTY457521Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Shift Paddle Switch [Transmission Shift Switch Assembly] RH)

      If the resistance values are not as specified, replace the shift paddle switch (transmission shift switch assembly) RH.

scientia non olet · About LEMON Manuals