LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Automatic Transmission System (A960E) - Service Information) >> Park / Neutral Position Switch >> Installation [04/2013 - 08/2015] >> Procedure

Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 

    HINT: 

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.

    1. Clean the bolt and the bolt hole.
    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Temporarily install the park/neutral position switch assembly to the automatic transmission assembly with the bolt.

      HINT: 

      Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

    4. Install a new nut stopper and the lock nut to the park/neutral position switch assembly.

      Torque: 6.9 N.m (70 kgf/cm, 61 in.lbf) 

    5. Temporarily install the transmission control shaft lever RH to the park/neutral position switch assembly with the spring washer and nut.

      HINT: 

      Tighten the nut to the specified torque when adjusting the park/neutral position switch assembly.

    6. Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.
      GTY456344Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transmission Control Shaft Lever RH
      *a P
      *b R
      *c N
    7. Remove the nut, spring washer and transmission control shaft lever RH from the park/neutral position switch assembly.
    8. Align the neutral basic line with the groove as shown in the illustration.
      GTY465342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Neutral Basic Line
      *b Groove
    9. Hold the park/neutral position switch assembly in that position and tighten the bolt.

      Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

    10. Using a screwdriver, stake the lock nut with the stopper plate.
    11. Install the transmission control shaft lever RH to the park/neutral position switch assembly with the spring washer and nut.

      Torque: 15.7 N.m (160 kgf/cm, 12 ft.lbf) 

    12. Connect the park/neutral position switch assembly connector.
  2. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Install the floor shift gear shifting rod sub-assembly to the transmission control shaft lever RH with the pin.
      GTY467834Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install a new clip.
  3. INSPECT SHIFT LEVER POSITION 

    See step  1

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION 

    See step  1

scientia non olet · About LEMON Manuals