LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Control System (2UR-GSE) - Service Information) >> Engine Oil Temperature Sensor >> Inspection [11/2021 - ] >> Procedure

Inspection [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ENGINE OIL TEMPERATURE SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY433289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Engine Oil Temperature Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 30°C (86°F) 7.512 to 9.124 kΩ
      NOTE:

      If checking the engine oil temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the engine oil temperature sensor.

      If the result is not as specified, replace the engine oil temperature sensor.

scientia non olet · About LEMON Manuals