LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Control System (2UR-GSE) - Service Information) >> Camshaft Oil Control Valve >> Installation [11/2021 - ] >> Procedure

Installation [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY RH 
    1. Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly RH.
      NOTE:

      Do not damage the O-ring.

    2. Install the camshaft timing oil control valve assembly RH to the cylinder head cover sub-assembly with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      NOTE:
      • If the camshaft timing oil control valve assembly RH has been struck or dropped, replace it.
      • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly RH (connecting surface with the cylinder head cover sub-assembly).
      • Make sure that the O-ring is not cracked or does not move out of place during installation.
    3. Connect the camshaft timing oil control valve assembly RH connector.
  2. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE 

    See step  2

  3. CONNECT VENTILATION HOSE 

    See step  3

  4. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY LH 
    1. Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly LH.
      NOTE:

      Do not damage the O-ring.

    2. Install the camshaft timing oil control valve assembly LH to the cylinder head cover sub-assembly LH with the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

      NOTE:
      • If the camshaft timing oil control valve assembly LH has been struck or dropped, replace it.
      • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly LH (connecting surface with the cylinder head cover sub-assembly LH).
      • Make sure that the O-ring is not cracked or does not move out of place during installation.
    3. Connect the camshaft timing oil control valve assembly LH connector.
    4. Engage the wire harness clamp.
  5. INSTALL V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 91

scientia non olet · About LEMON Manuals