LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Charging System (2UR-GSE) - Diagnostic Codes & Symptom Tests) >> Charging System >> DTC P161A: Lost Communication with Alternator [11/2021 - ] >> Procedure

DTC P161A: Lost Communication with Alternator [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CHARGING SYSTEM 
    1. Check the charging system.

      Refer to ON-VEHICLE INSPECTION [11/2021 - ] 

      Result

      Result
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE CHARGING SYSTEM 

    Result: 

    OK 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY) 
    1. Disconnect the ECM connector.
    2. Disconnect the generator assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      F153-18 (LIN) - F83-2 (LIN) Always Below 1 Ω
      F153-18 (LIN), F83-2 (LIN) - body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE GENERATOR ASSEMBLY. Refer to  REMOVAL [11/2021 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR