DTC P0010: Camshaft Position "A" Actuator Circuit (Bank 1); DTC P0020: Camshaft Position "A" Actuator Circuit (Bank 2) [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CAMSHAFT TIMING GEAR ASSEMBLY (BANK 1 OR BANK 2)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Camshaft Timing Gear Assembly
*2	Eccentric Shaft
*a	Spline

Turn the engine switch off.
Remove the camshaft timing control motor.
Refer to REMOVAL [11/2021 - ]

Check if the camshaft timing gear assembly eccentric shaft rotates smoothly.

Rotates smoothly.

HINT:

Perform "Inspection After Repair" after repairing or replacing the camshaft timing gear assembly, or removing or replacing the camshaft timing control motor.

Refer to INITIALIZATION [11/2021 - ]

Result

Proceed to
OK
NG

Result:

REPLACE CAMSHAFT TIMING CONTROL MOTOR (BANK 1 OR BANK 2). Refer to REMOVAL [11/2021 - ]

Result:

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY (BANK 1 OR BANK 2). Refer to DISASSEMBLY [11/2021 - ]