DTC P0711: Transmission Fluid Temperature Sensor "A" Performance [11/2021 - ]: Procedure
WARNING: This page is about a different car, the 2024 Lexus IS 500, 2023 Lexus IS 500, and 2022 Lexus IS 500. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / ECT / Trouble Codes.
Powertrain > ECT > Trouble Codes
- Read the DTCs using the Techstream.
Result
Result Proceed to Only DTC P0711 is output A DTC P0711 and other DTCs are output B HINT:
If any DTCs other than DTC P0711 are output, perform troubleshooting for those DTCs first.
Result:
B
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - ]
Result:
A
See step 2
- INSPECT TRANSMISSION FLUID LEVEL
- Check the transmission fluid level.
Refer to ADJUSTMENT [11/2021 - ]
OK
Automatic transmission fluid level is correct.
Result
Proceed to OK NG
Result:
OK
REPLACE TRANSMISSION WIRE (ATF TEMPERATURE SENSOR). Refer to COMPONENTS [11/2021 - ]
Result:
NG
ADJUST AUTOMATIC TRANSMISSION FLUID LEVEL. Refer to ADJUSTMENT [11/2021 - ]
- Check the transmission fluid level.