Initialization [08/2015 - 08/2019]

HINT: 

The oil change maintenance system displays "Maintenance Required Soon" in the multi-information display to inform the driver that it is time to change the oil, check the brakes, rotate the tires etc. based on the distance driven.

1. Turn the engine switch on (IG) and use the ODO/TRIP switch to change the screen display to TRIP A.
2. Turn the engine switch off.
3. While holding in the ODO/TRIP switch, turn the engine switch on (IG).
4. After a 5 second count, reset will end.
   Fig 1: Maintenance Data Reset Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   • If the engine switch is turned off during the reset operation, reset mode will be canceled.
   • If the ODO/TRIP switch is turned off during the reset operation, reset mode will be canceled.

HINT: 

• The eco driving indicator light can be disabled through the customize function.
• When the eco driving indicator light is disabled, the initial check for the eco driving indicator light is not performed by the system.

1. With the vehicle stationary or at a vehicle speed of less than 8 km/h (4.9 mph), press and hold the menu switch on the steering pad switch to display the meter customize mode screen.
   Fig 2: Reset Sequence Of "Eco Indicator Display"

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Press the ENTER switch on the steering pad switch up or down to display the "ECO INDICATOR DISPLAY SET" screen, and then press the ENTER switch (procedure A).
3. Press the ENTER switch on the steering pad switch up or down to select "OFF", and then press the ENTER switch (procedure B).

   HINT: 

   The eco driving indicator light can be enabled by selecting "ON".

4. Press the menu switch on the steering pad switch to end meter customize mode (procedure C).