Speedometer Malfunction [08/2019 - ]: Procedure

1. Check if a CAN communication DTC is output.

   Refer to DIAGNOSIS SYSTEM [08/2019 - 08/2020] , or refer to DIAGNOSIS SYSTEM [08/2020 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - ]

   Result

   Result	Proceed to
   CAN communication DTC is not output	A
   CAN communication DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

A 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [08/2019 - ]

   Result

   Result	Proceed to
   Vehicle stability control system DTCs are not output.	A
   Vehicle stability control system DTC is output.	B

Result: 

B 

GO TO VEHICLE STABILITY CONTROL SYSTEM. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2021 - ] 

Result: 

A 

See step  3

1. Perform the Active Test according to the display on the Techstream.

   Refer to DATA LIST / ACTIVE TEST [08/2019 - ]

   BODY ELECTRICAL > COMBINATION METER > ACTIVE TEST
   
   

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	for km/h:  OFF, 0, 40, 80, 120, 160, 200 (km/h) for mph:  OFF, 0, 40, 80, 120 (mph)	There is a deviation in the values displayed on the speedometer display (Control range → Speedometer) for km/h:  40 → 38.9 to 43.4 80 → 79.6 to 84.6 120 → 120.7 to 125.7 160 → 161.7 to 166.7 for mph:  40 → 39.7 to 42.5 80 → 80.5 to 83.7 120 → 121.8 to 124.8

   OK

   Speedometer indication is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MASTER CYLINDER SOLENOID (SKID CONTROL ECU). Refer to  DISASSEMBLY [08/2015 - ] 

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2019 - ]