Caution / Notice / Hint

NOTE:

If the vehicle speed is outside the allowable range when tested, perform the on-vehicle inspection.

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before starting the following inspection, inspect the speedometer and check that the tire size and air pressure are as specified.
- Tire size and air pressure:
  Refer to INSPECTION [08/2019 - ]
- Speedometer:
  Refer to OPERATION CHECK [08/2019 - ]