Engine Oil Level Sensor Circuit [08/2019 - ]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [08/2019 - 08/2020] , or refer to DIAGNOSIS SYSTEM [08/2020 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - ]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

A 

See step  2

1. Remove the engine oil level sensor.

   Refer to REMOVAL [08/2015 - ]

2. Inspect the engine oil level sensor.

   Refer to INSPECTION [08/2015 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE OIL LEVEL SENSOR. Refer to  REMOVAL [08/2015 - ] 

Result: 

OK 

See step  3

1. Disconnect the G3 combination meter assembly connector.
2. Disconnect the D6 engine oil level sensor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G3-29 (OIL) - D6-1 (LVL)	Always	Below 1 Ω
   D6-2 (E) - Body ground	Always	Below 1 Ω
   G3-29 (OIL) or D6-1 (LVL) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [08/2019 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR