How To Proceed With Troubleshooting [09/2014 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Check for DTCs and note any codes that are output (Refer to DTC CHECK / CLEAR [09/2014 - ] ).
2. Clear the DTCs (Refer to DTC CHECK / CLEAR [09/2014 - ] ).
3. Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system or meter/gauge system DTC by reproducing the symptoms indicated by the DTC.

   Result

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output	B
   Meter/gauge system DTC is output	C

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] )

Result: 

C 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 10/2015] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] ).

Result: 

A 

See step  4

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [09/2014 - 10/2015] , or refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  5

1. Terminals of ECU (Refer to TERMINALS OF ECU [09/2014 - 10/2015] , or refer to TERMINALS OF ECU [10/2015 - ] ).
2. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [09/2014 - 10/2015] , or refer to DATA LIST / ACTIVE TEST [10/2015 - ] ).
3. Operation Check (Refer to OPERATION CHECK [09/2014 - 10/2015] , or refer to OPERATION CHECK [10/2015 - ] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

Result

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

END