DTC B150B: Lost Communication with Gigabit Video Interface [10/2015 - ]: Procedure

1. Choose the model to be inspected.

   Result

   Result	Proceed to
   w/ Navigation System	A
   w/o Navigation System	B

Result: 

B 

See step  3

Result: 

A 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   OK

   DTCs are not output.

   Result

   Result
   OK
   NG

Result: 

NG 

GO TO NAVIGATION SYSTEM . Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] 

Result: 

OK 

See step  3

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   OK

   DTCs are not output.

   Result

   Result
   OK
   NG

Result: 

NG 

GO TO AUDIO AND VISUAL SYSTEM . Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] 

Result: 

OK 

See step  4

1. Replace the harness and connector (GVIF cable) with a new or normally functioning one.
2. Turn the engine switch on (IG) and wait 30 seconds.
   NOTE:

   A maximum of 30 seconds is required to send/receive the registration information between the combination meter assembly and radio receiver assembly.

3. Operate the steering pad switch assembly and check that the audio tab illuminates.
4. Check for DTCs and check the display status of the multi-information display.

   Refer to DTC CHECK / CLEAR [09/2014 - ]

   OK

   The audio information illuminates and DTC B150B is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (GVIF CABLE IS DEFECTIVE) 

Result: 

NG 

See step  5

1. Replace the combination meter assembly.

   Refer to REMOVAL [09/2014 - ]

2. Turn the engine switch on (IG) and wait 30 seconds.
   NOTE:

   A maximum of 30 seconds is required to send/receive the registration information between the combination meter assembly and radio receiver assembly.

3. Operate the steering pad switch assembly and check that the audio tab illuminates.
4. Check for DTCs and check the display status of the multi-information display.

   Refer to DTC CHECK / CLEAR [09/2014 - ]

   OK

   The audio information illuminates and DTC B150B is not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (COMBINATION METER ASSEMBLY IS DEFECTIVE) 

Result: 

NG 

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY . Refer to  REMOVAL [09/2014 - 09/2017]  Refer to  REMOVAL [09/2017 - ]