Inspection [09/2014 - 10/2015]: Procedure
- INSPECT CLOCK ASSEMBLY
- Apply battery voltage to the connector and check the operation.
OK
Measurement Condition Switch Condition Specified Condition Battery positive (+) → Terminal 1 (B)
Battery negative (-) → Terminal 5 (E)Knob A on
(Pushed)Long hand rotates clockwise Knob B on
(Pushed)Long hand rotates counterclockwise Battery positive (+) → Terminal 3 (ACC)
Battery negative (-) → Terminal 5 (E)Knob A on
(Pushed)Long hand rotates clockwise Knob B on
(Pushed)Long hand rotates counterclockwise If the result is not as specified, replace the clock assembly.
TEXT IN ILLUSTRATION*1 Knob A *2 Knob B *a Component without harness connected
(Clock Assembly) Apply battery voltage to the connector and check the illumination condition.
OK
Measurement Condition Specified Condition Battery positive (+) → Terminal 2 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)Illuminates If the result is not as specified, replace the clock assembly.
TEXT IN ILLUSTRATION*a Component without harness connected
(Clock Assembly)
- Apply battery voltage to the connector and check the operation.