DTC B1500: Fuel Sender Open Detected [07/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Read the Data List according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Fuel Input	Fuel input/Min.: 0 L, Max.: 127.5 L	Fuel receiver gauge indicates F: 57.9 L	-
   		Fuel receiver gauge indicates 1/2: 32.2 L
   		Fuel receiver gauge indicates E: 6.4 L

   Result

   Result	Proceed to
   Fuel level data can be displayed on the Techstream and DTC B1500 is output.	A
   Fuel level data cannot be displayed on the Techstream.	B

Result:  A

A 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [07/2015 - ] )

Result:  B

B 

See step  2

1. Disconnect the H14 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H14-27 (FR) - H14-28 (FE)	Always	13.5 to 414.5 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

Result:  OK

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [07/2015 - ] )

Result:  NG

NG 

See step  3

1. Disconnect the P7 fuel suction tube with pump and gauge assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H14-27 (FR) - P7-2 (FS)	Always	Below 1 Ω
   H14-27 (FR) - Body ground	Always	10 kΩ or higher
   H14-28 (FE) - P7-3 (FE)	Always	Below 1 Ω
   H14-28 (FE) - Body ground	Always	10 kΩ or higher

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result:  OK

OK 

See step  4

1. Remove the fuel sender gauge assembly (Refer to REMOVAL [07/2015 - ] ).
2. Inspect the fuel sender gauge assembly (Refer to INSPECTION [07/2015 - ] ).

Result:  NG

NG 

REPLACE FUEL SENDER GAUGE ASSEMBLY 

(Refer to REMOVAL [07/2015 - ] )

Result:  OK

OK 

See step  5

1. Visually check for deformation on the fuel suction tube with pump and gauge assembly connector.

   OK

   There is no deformation.

Result:  OK

OK 

REPLACE COMBINATION METER ASSEMBLY 

(Refer to REMOVAL [07/2015 - ] )

Result:  NG

NG 

REPLACE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

(Refer to REMOVAL [07/2015 - ] )