Entire Combination Meter does not Operate [07/2015 - ]: Procedure

1. Disconnect the H14 combination meter assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H14-31 (ES) - Body ground	Always	Below 1 Ω
   H14-40 (EP) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H14-21 (IG+) - Body ground	Power switch off	Below 1 V
   	Power switch on (IG)	11 to 14 V
   H14-22 (B) - Body ground	Power switch off	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Combination Meter Assembly)

Result:  OK

OK 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [07/2015 - ]

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR