Installation [09/2015 - 12/2017]: Procedure

1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Stopper

   NOTE:

   Be sure to install the rear stabilizer bushings so that each cutout faces the bottom of the vehicle.

1. Install the 2 rear No. 1 stabilizer bar brackets to the 2 rear stabilizer bushings.
   NOTE:

   • Ensure that the identification mark faces the right side of the vehicle.
   • Ensure that the identification shape faces upward.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Shape
   *b	Identification Mark

1. Install the rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings to the rear suspension member sub-assembly with the 4 nuts.

   Torque: 75 N*m (765 kgf*cm, 55 ft.*lbf) 

   NOTE:

   Ensure that the identification mark faces the right side of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

1. Secure the rear lower stabilizer bracket in a vise using aluminum plates.
   NOTE:

   Do not overtighten the vise.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the rear stabilizer link assembly LH to the rear lower stabilizer bracket with the nut.

   Torque: 92 N*m (938 kgf*cm, 68 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

3. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (B).

   Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf) 

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Install the rear stabilizer link assembly LH to the rear No. 2 suspension arm assembly LH with the 2 nuts (A).

   Torque: 82 N*m (836 kgf*cm, 60 ft.*lbf) 

HINT: 

Perform the same procedure as for the LH side.