Inspection [10/2014 - ]: Procedure

INSPECT TRIP SWITCH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	ODO TRIP Switch
*a	Component without harness connected (Trip Switch)

Check the resistance.

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
4 (A/B) - 5 (E)	ODO TRIP switch on (Pushed)	Below 1 Ω
4 (A/B) - 5 (E)	ODO TRIP switch off (Not pushed)	10 kΩ or higher

If the result is not as specified, replace the trip switch.

Check the illumination.

Apply battery voltage to the connector and check the illumination condition.

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 1 (ILL+) Battery negative (-) → Terminal 3 (ILL-)	Illuminates

If the result is not as specified, replace the trip switch.

*a	Component without harness connected (Trip Switch)