Removal [10/2014 - ]: Procedure

REMOVE CONSOLE ARMREST ASSEMBLY
Refer to PROCEDURE - Step 5 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 5 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 5 [05/2019 - ]
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 7 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 7 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 7 [05/2019 - ]
REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 9 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 9 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 9 [05/2019 - ]
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 10 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 10 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 10 [05/2019 - ]
REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 11 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 11 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 11 [05/2019 - ]
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 12 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 12 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 12 [05/2019 - ]
REMOVE NO. 1 SWITCH HOLE BASE
Refer to PROCEDURE - Step 13 [10/2014 - 09/2017] , or refer to PROCEDURE - Step 13 [09/2017 - 05/2019] , or refer to PROCEDURE - Step 13 [05/2019 - ]

REMOVE HEADUP DISPLAY SWITCH ASSEMBLY

Using a screwdriver, detach the 4 claws and remove the headup display switch assembly.

HINT:

Tape the screwdriver tip before use.

*1	Protective Tape