LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LX 570 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (Service Information) >> Drive Belt >> Installation [09/2015 - ] >> Procedure

Installation [09/2015 - ]: Procedure

  1. INSTALL FAN AND GENERATOR V BELT 
    1. Set the V belt onto every part.
      Fig 1: Generator V Belt Routing Diagram
      GTY628550Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. While turning the belt tensioner counterclockwise, remove the bar.
      NOTE:

      Make sure that the V belt is properly set to each pulley.

    3. GTY650910Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      After installing the belt, check that it fits properly in the ribbed grooves.

      HINT: 

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 15

  4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 16

  5. INSTALL V-BANK COVER SUB-ASSEMBLY 

    See step  69

  6. INSTALL UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 14

scientia non olet · About LEMON Manuals