LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire Pressure Warning System - Service Information >> Tire Pressure Warning Receiver >> Removal [09/2015 - ] >> Procedure

Removal [09/2015 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing (Refer to PRECAUTION [09/2015 - ] ).

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work (Refer to PRECAUTION [09/2015 - ] ).

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  3. REMOVE BATTERY SERVICE HOLE COVER LH 

    Refer to PROCEDURE - Step 4

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).

  5. REMOVE TELEMATICS TRANSCEIVER 

    (Refer to REMOVAL [09/2015 - ] )

  6. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER 
    1. Disconnect the connector.
      GTY407098Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and tire pressure warning ECU and receiver.
scientia non olet · About LEMON Manuals