DTC P0012: Camshaft Position "A" - Timing Over-Retarded (Bank 1); DTC P0022: Camshaft Position "A" - Timing Over-Retarded (Bank 2) [09/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Read DTCs.
   RESULT
   
   

   Display (DTC Output)	Proceed to
   P0012 or P0022	A
   P0012 or P0022 and other DTCs	B

Result:  B

B 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ] )

Result:  A

A 

See step  2

1. Turn the power switch off.
2. Remove the camshaft timing control motor (Refer to REMOVAL [09/2015 - ] ).
3. Check if the camshaft timing gear assembly's eccentric shaft rotates smoothly.

   OK

   Rotates smoothly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Result:  NG

NG 

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY (for Bank 1 or Bank 2) 

(Refer to DISASSEMBLY [09/2015 - ] )

Result:  OK

OK 

See step  3

1. Replace the camshaft timing control motor (Refer to REMOVAL [09/2015 - ] ).

Result:  NEXT

NEXT 

See step  4

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear DTCs (Refer to DTC CHECK / CLEAR [09/2015 - ] ).
5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
7. Read the DTCs.
   RESULT
   
   

   Display (DTC Output)	Proceed to
   No output	A
   Other DTCs	B

Result:  A

A 

END 

Result:  B

B 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ] )