LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> LS 600h >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostic Codes & Symptom Tests >> Symptom Tests >> Speedometer Malfunction [09/2015 - ] >> Procedure

Speedometer Malfunction [09/2015 - ]: Procedure

  1. CHECK CAN COMMUNICATION SYSTEM 
    1. Check for DTC (Refer to DIAGNOSIS SYSTEM [09/2015 - ] ).
      RESULT

      Result Proceed to
      CAN communication system DTC is not output A
      CAN communication system DTC is output B

    Result:  B

    B 

    Go to CAN COMMUNICATION SYSTEM 

    (Refer to PRECAUTION [09/2015 - ] )

    Result:  A

    A 

    See step  2

  2. PERFORM ACTIVE TEST USING TECHSTREAM (SPEEDOMETER) 
    1. Operate the Techstream according to the display and select or "Active Test".
      COMBINATION METER

      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120, 160, 200, 240 or 280 Acceptable range (mph or km/h): [Control range → Speedometer display]
      for mph 
      • 40 → 39.4 to 42.2
      • 80 → 79.9 to 83.1
      • 120 → 120.7 to 123.9

      for km/h 
      • 40 → 38.6 to 43.1
      • 80 → 79 to 84
      • 120 → 119.8 to 124.8
      • 160 → 160.5 to 165.5
      • 200 → 201.3 to 206.3
      • 240 → 242.1 to 247.1

      OK

      Needle indication is normal.

    Result:  NG

    NG 

    REPLACE NO. 1 METER ECU 

    (Refer to DISASSEMBLY [09/2015 - ] )

    Result:  OK

    OK 

    See step  3

  3. READ VALUE USING TECHSTREAM (VEHICLE SPEED) 
    1. Operate the Techstream according to the display and select "Data List".
      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Vehicle Speed Meter Vehicle speed/Min.: 0 (0), Max.: 255 (158) Almost same as actual speed (When driving) Unit: km/h (mph)

      OK

      Vehicle speed displayed on the Techstream is almost the same as actual vehicle speed measured using speedometer tester (calibrated chassis dynamometer).

    Result:  OK

    OK 

    REPLACE NO. 1 METER ECU 

    (Refer to DISASSEMBLY [09/2015 - ] )

    Result:  NG

    NG 

    See step  4

  4. READ VALUE USING TECHSTREAM (WHEEL SPEED SENSOR) 
    1. Operate the Techstream according to the display and select "Data List".

      OK

      Vehicle speed displayed on the Techstream is almost the same as actual vehicle speed measured using speedometer tester (calibrated chassis dynamometer).

      ELECTRIC PARKING BRAKE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      (FL/FR/RL/RR) Wheel Speed Wheel speed sensor (FL/FR/RL/RR) reading / Min.: 0 (0), Max.: 326 (202) Actual wheel speed Similar speed as indicated on speedometer

    Result:  OK

    OK 

    REPLACE NO. 1 METER ECU 

    (Refer to DISASSEMBLY [09/2015 - ] )

    Result:  NG

    NG 

    Go to ELECTRONICALLY CONTROLLED BRAKE SYSTEM 

    (Refer to PRECAUTION [09/2015 - ] )