Hybrid System Indicator Malfunction [09/2015 - ]: Procedure

1. Check for DTC (Refer to DIAGNOSIS SYSTEM [09/2015 - ] ).
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output	B
   Hybrid control system DTC is output	C

Result:  B

B 

Go to CAN COMMUNICATION SYSTEM 

(Refer to PRECAUTION [09/2015 - ] )

Result:  C

C 

Go to HYBRID CONTROL SYSTEM 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2015 - ] )

Result:  A

A 

See step  2

1. Operate the Techstream according to the display and select "Active Test".
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   HV System Indicator	Hybrid system indicator	MIN, -50, 0, 100, 200, 300, 400 or MAX (%)	-

   OK

   Needle indication is normal.

Result:  OK

OK 

Go to HYBRID CONTROL SYSTEM 

(Refer to PROBLEM SYMPTOMS TABLE [09/2015 - ] )

Result:  NG

NG 

REPLACE NO. 1 METER ECU 

(Refer to DISASSEMBLY [09/2015 - ] )