Inspection [09/2015 - ]: Procedure
- INSPECT TRIP SWITCH (w/o Night View System)
- Inspect the trip switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 7 (A/B) - 6 (E) TRIP switch pushed Below 200 Ω Off 10 kΩ or higher 5 (RSET) - 6 (E) RESET switch pushed Below 200 Ω Off 10 kΩ or higher - Apply battery voltage to the switch connector and check that the trip switch illuminates.
OK
Measurement Condition Specified Condition Battery positive (+) → 2 (ILL+)
Battery negative (-) → 8 (ILL-)Illumination illuminates If the result is not as specified, replace the trip switch.
TEXT IN ILLUSTRATION*a Component without harness connected
(Trip switch)
- Measure the resistance according to the value(s) in the table below.
- Inspect the trip switch.
- INSPECT TRIP SWITCH (w/ Night View System)
- Inspect the trip switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 7 (A/B) - 6 (E) TRIP switch pushed Below 200 Ω Off 10 kΩ or higher 5 (RSET) - 6 (E) RESET switch pushed Below 200 Ω Off 10 kΩ or higher 4 - 6 (E) Night view switch pushed Below 200 Ω Off 10 kΩ or higher - Apply battery voltage to the switch connector and check that the trip switch illuminates.
OK
Measurement Condition Specified Condition Battery positive (+) → 2 (ILL+)
Battery negative (-) → 8 (ILL-)Illumination illuminates If the result is not as specified, replace the trip switch.
TEXT IN ILLUSTRATION*1 Night view switch *a Component without harness connected
(Trip switch)
- Measure the resistance according to the value(s) in the table below.
- Inspect the trip switch.