LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> IS 350 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System (2GR-FSE) - Service Information >> Starter >> Installation [04/2013 - 10/2017] >> Procedure

Installation [04/2013 - 10/2017]: Procedure

  1. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 58 N*m (591 kgf*cm, 43 ft.*lbf) 

    2. Connect the wire harness, install the nut and close the terminal cap.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    3. Connect the starter connector.
  2. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH(TWC: Front Catalyst) 

    Refer to INSTALLATION [04/2013 - 10/2016] , or refer to INSTALLATION [10/2016 - 10/2017]

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [04/2013 - 06/2014] , or refer to INITIALIZATION [06/2014 - 08/2015] , or refer to INITIALIZATION [08/2015 - 10/2016] , or refer to INITIALIZATION [10/2016 - 10/2017]

scientia non olet · About LEMON Manuals