Inspection [08/2019 - ]: Procedure

1. Check the tires for wear and proper inflation pressure.

   Cold Tire Inflation Pressure (Unloaded Vehicle)

   Tire Size	Front kPa (kgf/cm2 , psi)	Rear kPa (kgf/cm2 , psi)
   P265/60R18 109H	220 (2.2, 32)	220 (2.2, 32)
   265/55R19 109V	220 (2.2, 32)	220 (2.2, 32)

2. Using a dial indicator, check the tire runout.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard tire runout

   3.0 mm (0.118 in.) or less

1. Rotate the tires as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

   TEXT IN ILLUSTRATION
   
   

   *a	Front of the Vehicle

1. Check and adjust the off-the-car balance.
2. If necessary, check and adjust the on-the-car balance.

   Standard Imbalance after Adjustment

   6.0 g (0.0132 lb) or less

   NOTE:

   • The imbalance after adjustment value is the conversion value at the rim flange position.
   • Using a cleaning detergent, remove dirt, oil and water from the surface where the balance weight is to be adhered.
   • Do not touch the adhesive surface of the tape.
   • Attach a sticking type balance weight to the flat surface (A) shown in the illustration.

     Width (A)

     25 mm (0.984 in.)

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

     *A	for 18 inch
     *B	for 19 inch

   • Push the balance weight securely with your finger so that it securely adheres to the position.
   • Do not reuse the balance weight.
   • Use the LEXUS genuine sticking type balance weights.

   HINT: 

   • If the tires vibrate even after off-the-car balance adjustment, adjust the wheel balance with on-the-car balancing as necessary.
   • for 19 inch:

     The inner side balance weights should be installed by clipping them to the rim.

(Refer to ON-VEHICLE INSPECTION [08/2015 - ] )

(Refer to INSPECTION [08/2015 - ] )