Removal [08/2021 - ]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Refer to PRECAUTION [08/2015 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2021 - 08/2022] , or refer to INITIALIZATION [08/2022 - ]
REMOVE DOOR SCUFF PLATE ASSEMBLY RH
Refer to PROCEDURE - Step 7
REMOVE COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 9
REMOVE INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 26
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 27
REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 28
REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 2
REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Refer to PROCEDURE - Step 6
REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 4
REMOVE LOWER INSTRUMENT COVER LH
Refer to PROCEDURE - Step 29
REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE INSTRUMENT PANEL BOX DOOR COVER
Refer to PROCEDURE - Step 31
REMOVE INSTRUMENT PANEL BOX ASSEMBLY
Refer to PROCEDURE - Step 32

REMOVE DCM (TELEPHONE TRANSCEIVER ASSEMBLY) WITH BRACKET

Disconnect the 6 connectors.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and nut.
Detach the guide and remove the DCM (telephone transceiver assembly) with bracket.

REMOVE NO. 1 TELEPHONE BRACKET

Remove the 2 screws and No. 1 telephone bracket.

REMOVE NO. 2 TELEPHONE BRACKET

Remove the 2 screws and No. 2 telephone bracket.