Removal [08/2015 - 08/2021]: Procedure
- PRECAUTION NOTE:
After turning the engine switch is turned off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Refer to PRECAUTION [08/2015 - ] ).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] , or refer to INITIALIZATION [08/2019 - 08/2021] ).
- REMOVE INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 5 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 5 [08/2019 - 08/2021]
- REMOVE INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 6 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 6 [08/2019 - 08/2021]
- REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 7 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 7 [08/2019 - 08/2021]
- REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 8 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 8 [08/2019 - 08/2021]
- REMOVE FRONT UPPER CONSOLE PANEL GARNISH
Refer to PROCEDURE - Step 36 [08/2015 - 08/2019] , or refer to PROCEDURE - Step 35 [08/2019 - 08/2021]
- REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY
- Remove the 4 bolts.TEXT IN ILLUSTRATION
*A w/o Navigation System *B w/ Navigation System - Pull the multi-media module receiver assembly to detach the 6 clips and guide on the backside of the multi-media module receiver assembly.TEXT IN ILLUSTRATION
*A w/o Navigation System *B w/ Navigation System - Disconnect each connector and remove the multi-media module receiver assembly.
- Remove the 4 bolts.
- REMOVE NO. 1 RADIO BRACKET
- REMOVE NO. 2 RADIO BRACKET