LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2016 >> GX 460 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display System (Diagnostics - Introduction) (2 Of 2) >> Meter / Gauge System >> Data List / Active Test [08/2019 - ] >> Data List / Active Test [08/2019 - ]

Data List / Active Test [08/2019 - ]

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus:
      1. Body Electrical / Combination Meter / Data List.
      2. Chassis / ABS/VSC/TRAC / Data List.
    5. Read the Data List according to the display on the Techstream.
      BODY ELECTRICAL > COMBINATION METER > DATA LIST

      Tester Display Measurement Item / Range Normal Condition Diagnostic Note
      ODO/TRIP Change SW ODO/TRIP switch / OFF or ON OFF: ODO/TRIP switch released
      ON: ODO/TRIP switch pushed
      -
      Vehicle Speed Meter Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed (Speedometer tester) -
      Engine Rpm Engine speed / Min.: 0 rpm, Max.: 12750 rpm 650 to 750 rpm (When idling) -
      Washer Switch Washer switch / OFF or ON OFF: Washer fluid level not low
      ON: Washer fluid level low
      -
      Coolant Temperature Engine coolant temperature / Min. 0°C (0°F), Max.: 127.5°C (261.5°F) After warming up: 80 to 95°C (176 to 203°F) -
      Oil Level SW Engine oil level sensor / OFF or ON OFF: Engine oil level not low
      ON: Engine oil level low
      -
      Light Control Up Switch Light control rheostat up switch / OFF or ON OFF: Light control rheostat up switch not pressed
      ON: Light control rheostat up switch pressed
      -
      Light Control Down Switch Light control rheostat down switch / OFF or ON OFF: Light control rheostat up switch not pressed
      ON: Light control rheostat up switch pressed
      -
      +B Voltage Value Battery voltage / Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Fuel Input Fuel input signal / Min.: 0, Max. 127.5 L
      • Fuel receiver gauge indicates F: 78.3
      • Fuel receiver gauge indicates 3/4: 62.2
      • Fuel receiver gauge indicates 1/2: 46.1
      • Fuel receiver gauge indicates 1/4: 27.4
      • Fuel receiver gauge indicates E: 8.7
      Unit: Liters
      Ambient Temperature Outside temperature / Min.: -40°C, Max.: 87.5°C Almost same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F).
      Rheostat value Light control rheostat switch input / Min.: 0, Max.: 100 Dark (0) → Bright (100) Unit: %
      Multi Switch (Up) Steering pad switch assembly (up switch) signal / OFF or ON OFF: Steering pad switch assembly (up switch) released
      ON: Steering pad switch assembly (up switch) pushed
      -
      Multi Switch (Down) Steering pad switch assembly (down switch) signal / OFF or ON OFF: Steering pad switch assembly (down switch) released
      ON: Steering pad switch assembly (down switch) pushed
      -
      Multi Switch (Menu) Steering pad switch assembly (menu switch) signal / OFF or ON OFF: Steering pad switch assembly (menu switch) released
      ON: Steering pad switch assembly (menu switch) pushed
      -
      Multi Switch (Enter) Steering pad switch assembly (enter switch) signal / OFF or ON OFF: Steering pad switch assembly (enter switch) released
      ON: Steering pad switch assembly (enter switch) pushed
      -
      Multi Switch (Right) Steering pad switch assembly (right switch) signal / OFF or ON OFF: Steering pad switch assembly (right switch) released
      ON: Steering pad switch assembly (right switch) pushed
      -
      Multi Switch (Left) Steering pad switch assembly (left switch) signal / OFF or ON OFF: Steering pad switch assembly (left switch) released
      ON: Steering pad switch assembly (left switch) pushed
      -
      Oil Pressure Switch Oil pressure switch / OFF or ON OFF: Engine oil pressure not low
      ON: Engine oil pressure low
      -
      Turn Signal Switch (Right) Turn signal switch (right) / OFF or ON OFF: Turn signal switch (right) released
      ON: Turn signal switch (right) pushed
      -
      Turn Signal Switch (Left) Turn signal switch (left) / OFF or ON OFF: Turn signal switch (left) released
      ON: Turn signal switch (left) pushed
      -
      Hazard Flasher Switch Hazard warning signal switch / OFF or ON OFF: Hazard warning signal switch released
      ON: Hazard warning signal switch pushed
      -
      Multi Switch (Back) Steering pad switch assembly (back switch) signal / OFF or ON OFF: Steering pad switch assembly (back switch) released
      ON: Steering pad switch assembly (back switch) pushed
      -
      Battery Charge Battery charge signal / OK or NG OK: Battery charge normality
      NG: Battery charge abnormality
      -
      Driver Side Seatbelt Warning Buzzer Condition of driver side seat belt warning buzzer / OFF or ON Customized setting displayed -
      P-Seatbelt Warning Buzzer Condition of front passenger side seat belt warning buzzer / OFF or ON Customized setting displayed -
      ODO Display Time After IG OFF Setting Condition of the ODO display time after the engine switch is turned off / 30s, 60s, 600s or OFF Customized setting displayed -
      Flasher Sound Volume Adjustment Setting of flasher sound volume adjustment / Large, Medium or Small Customized setting displayed -
      TPMS System Existence of tire pressure warning system / With or Without With: w/ Tire Pressure Warning System
      Without: w/o Tire Pressure Warning System
      -
      LDA System Existence of lane departure alert system / With or Without With: w/ Lane Departure Alert System
      Without: w/o Lane Departure Alert System
      -
      PCS System Existence of pre-collision system / With or Without With: w/ Pre-collision System
      Without: w/o Pre-collision System
      -
      Flasher Sound Tone Setting Setting of flasher sound tone / Tone 1, Tone 2 or Tone 3 Customized setting displayed -
      Intuitive P/A System Existence of intuitive parking assist system / With or Without With: w/ Intuitive Parking Assist System
      Without: w/o Intuitive Parking Assist System
      -
      Road Sign Assist System Existence of road sign assist system / With or Without With: w/ Road Sign Assist System
      Without: w/o Road Sign Assist System
      -
      Integrated value for Maintenance Oil maintenance information integrated value/Min.: 0, Max.: 25500 (mile) Driving distance after performing oil maintenance resetting procedure displayed If the value is 5000 (miles) or more, perform the oil maintenance resetting procedure after changing the oil.
      Number of Trouble Code Number of currently stored DTCs / Min.: 0, Max.: 255 0 -
      CHASSIS > ABS/VSC/TRC > DATA LIST

      Tester Display Measurement Item / Range Normal Condition Diagnostic Note
      Vehicle Speed Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. Perform the Active Test according the display on the Techstream.
      BODY ELECTRICAL > COMBINATION METER > ACTIVE TEST

      Tester Display Measurement Item Control Range Diagnostic Note
      Speed Meter Operation Speedometer for km/h: 
      • OFF, 0, 40, 80, 120, 160, 200 (km/h)

      for mph: 
      • OFF, 0, 40, 80, 120 (mph)
      There is a deviation in the values displayed on the speedometer display (Control range → Speedometer)
      for km/h: 
      • 40 → 38.9 to 43.4
      • 80 → 79.6 to 84.6
      • 120 → 120.7 to 125.7
      • 160 → 161.7 to 166.7

      for mph: 
      • 40 → 39.7 to 42.5
      • 80 → 80.5 to 83.7
      • 120 → 121.8 to 124.8
      TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F See [Display 1]
      A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3, 4, D, N, R, P -
      A/T Indicator Operation 2 Shift indicator OFF, 5, 6, S -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Door open indicator light OFF or ON -
      Driver Side Seat Belt Seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Head Headlight indicator light OFF or ON -
      Indicat. Lamp Tail Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON w/ Front Fog Light
      Indicat. Pre-Collision PCS OFF indicator light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator TRAC OFF indicator light OFF or ON -
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON -
      Indicat. ECONO Eco driving indicator light OFF or ON -
      Indicat. Lamp Brake BRAKE warning light OFF or ON -
      Indicat. INTUITIVE P/A LCD Clearance sonar indicator light OFF or ON -
      Indicat. Downhill Assist Control Downhill assist control indicator light OFF or ON -
      Indicat. Park Parking brake warning light OFF or ON w/ Intuitive Parking Assist System
      Indicat. 2nd START 2nd start indicator light OFF or ON -
      Indicat. Ctr DIFF LOCK Center differential lock indicator light OFF or ON -
      Indicat. 4LO 4LO indicator light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Automatic High Beam Indicator Automatic high beam indicator light OFF or ON -
      KDSS Indicator Kinetic dynamic suspension system indicator light OFF or ON -
      Turn Signal (Left) Indicator Turn Indicator light (LH) OFF or ON -
      Turn Signal (Right) Indicator Turn Indicator light (RH) OFF or ON -
      Check Engine Indicator MIL (Malfunction indicator light) OFF or ON -
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH See [Display 2]
      BSM Control indicator BSM indicator light OFF or ON -
      Meter Display 1 Multi-information display OFF, All -
      1. [Display 1]: Fuel receiver gauge
        Fig 1: [Display 1]: Fuel receiver gauge
        GTY960581Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Fuel Gauge Operation (Sender E)
        *b Fuel Gauge Operation (Empty)
        *c Fuel Gauge Operation (Warning)
        *d Fuel Gauge Operation (1/4)
        *e Fuel Gauge Operation (1/2)
        *f Fuel Gauge Operation (3/4)
        *g Fuel Gauge Operation (Full)
        *h Fuel Gauge Operation (Sender F)
      2. [Display 2]: Engine coolant temperature receiver gauge
        Fig 2: [Display 2]: Engine coolant temperature receiver gauge
        GTY961673Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Water Temperature Gauge Operation (LOW)
        *b Water Temperature Gauge Operation (NORMAL)
        *c Water Temperature Gauge Operation (HIGH)