Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the combination meter removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [10/2015 - ] |
| Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [10/2015 - ] | ||
| Pre-collision system | |||
| Reset power trunk lid | Power trunk lid system | Refer to INITIALIZATION [10/2015 - ] |