Hybrid System Indicator Malfunction [07/2015 - ]: Procedure

1. Check if CAN communication DTCs are output. Refer to DIAGNOSIS SYSTEM [07/2015 - 08/2016] Refer to DIAGNOSIS SYSTEM [08/2016 - ] w/ Central Gateway ECU. Refer to DIAGNOSIS SYSTEM [07/2015 - 08/2016] Refer to DIAGNOSIS SYSTEM [08/2016 - ] w/o Central Gateway ECU

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output (w/ Central Gateway ECU).	B
   CAN communication DTCs are output (w/o Central Gateway ECU).	C

Result:  B

B 

GO TO CAN COMMUNICATION SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2015 - ]

Result:  C

C 

GO TO CAN COMMUNICATION SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2015 - ]

Result:  A

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	MIN
   *b	-50%
   *c	0%
   *d	100%
   *e	200%
   *f	300%
   *g	400%
   *h	MAX

   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   HV System Indicator	Hybrid system indicator	OFF, MIN, -50, 0, 100, 200, 300, 400, MAX	-

   OK

   Hybrid system indicator indication is normal.

Result:  NG

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [07/2015 - ]

Result:  OK

OK 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Data Test.
5. Read the Data List according to the display on the Techstream.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Hybrid System Indicator	Hybrid system indicator value/ Min.: -512%, Max.: 511%	-512 to 511%	-

   OK

   Hybrid system indicator value displayed on the Techstream is almost the same as hybrid system indicator indication.

Result:  NG

NG 

GO TO HYBRID CONTROL SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2015 - ]

Result:  OK

OK 

See step  4

1. Replace the combination meter assembly with a new one. Refer to REMOVAL [07/2015 - ]

   OK

   The operation of the hybrid system indicator returns to normal.

Result:  OK

OK 

END 

Result:  NG

NG 

REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY 

Refer to REMOVAL [07/2015 - ]