LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> RC 350 Base, RWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seats - Service Information >> Rear Seat Assembly >> Removal [11/2017 - ] >> Procedure

Removal [11/2017 - ]: Procedure

  1. REMOVE REAR SEAT CUSHION ASSEMBLY 
    1. Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the rear seat cushion frame hook on the front side of the rear seat cushion assembly from the rear seat cushion lock hook.
      NOTE:

      Be sure to hold the part of the rear seat cushion assembly directly next to the rear seat cushion lock hooks when lifting it up. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.

      HINT: 

      Use the same procedure for the RH side and LH side.

      Standard Measurement

      Area Measurement
      A 100 mm (3.94 in.) or less
      B 121.1 mm (4.77 in.)
      GTY796516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Rear Seat Cushion Frame Hook
      *b Child Restraint Seat Anchor Bracket Hook
      Remove in this Direction
    2. Disengage the 2 rear seat cushion frame hooks on the rear side of the rear seat cushion assembly from the 2 child restraint seat anchor bracket hooks.
    3. Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
      NOTE:

      Be careful not to damage the vehicle body.

  2. REMOVE REAR SEAT CUSHION LOCK HOOK 
    1. Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
      GTY504733Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

  3. REMOVE REAR SEAT HEADREST ASSEMBLY 
    1. Remove the 2 rear seat headrest assemblies.
  4. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH 

    Refer to PROCEDURE - Step 6

  5. REMOVE REAR SIDE SEATBACK ASSEMBLY LH 
    1. Remove the 2 bolts.
      GTY511363Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pass the rear seat 3 point type outer belt assembly LH through the rear side seatback assembly LH and remove the rear side seatback assembly LH.
      NOTE:

      Be careful not to damage the vehicle body.

  6. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  7. REMOVE REAR SIDE SEATBACK ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  8. REMOVE REAR SEATBACK ASSEMBLY RH 
    1. Fold the rear seatback assembly RH forward.
    2. Disengage the 2 clips and fastener.
      GTY496372Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fastener
    3. Disengage the 5 fasteners.
      GTY512476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fastener
    4. Remove the 3 bolts.
      GTY519085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the guide to remove the rear seatback assembly RH.
      NOTE:

      Be careful not to damage the vehicle body.

  9. REMOVE REAR SEATBACK ASSEMBLY LH 
    1. Fold the rear seatback assembly LH forward.
    2. Disengage the 3 clips and 2 fasteners.
      GTY498281Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fastener
    3. Disengage the 5 fasteners.
      GTY497548Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fastener
    4. Remove the 3 bolts.
      GTY504721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the guide to remove the rear seatback assembly LH.
      NOTE:

      Be careful not to damage the vehicle body.

scientia non olet · About LEMON Manuals