LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> NX 300h FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System - Diagnostic Codes (3 Of 3) & Symptom Tests >> Airbag System >> Diagnosis Circuit [10/2014 - 05/2019] >> Procedure

Diagnosis Circuit [10/2014 - 05/2019]: Procedure

  1. CHECK CAN COMMUNICATION SYSTEM 
    1. Check if a CAN communication DTC is output.

      Refer to DIAGNOSIS SYSTEM [10/2014 - 09/2017] , or refer to DIAGNOSIS SYSTEM [09/2017 - 05/2018] , or refer to DIAGNOSIS SYSTEM [05/2018 - 05/2019]

      Result

      Proceed to
      DTCs are output
      DTC is not output

    Result: 

    DTCs are output 

    GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2017 - 05/2019] 

    Result: 

    DTC is not output 

    See step  2

  2. CHECK HARNESS AND CONNECTOR (DLC3 - HYBRID VEHICLE CONTROL ECU) 
    1. Turn the power switch off.
      GTY508769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of DLC3 *b Front view of wire harness connector
      (to Hybrid Vehicle Control ECU)
    2. Disconnect the connector from the Hybrid Vehicle Control ECU.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I7-13 (TC) - I116-28 (TC) Always Below 1 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I7-4 (CG) - Body ground Always Below 1 Ω
      GTY512844Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of DLC3

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  4

  4. CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I116-28 (TC) - Body ground Always Below 1 Ω
      GTY518728Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Hybrid Vehicle Control ECU)

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE AIRBAG ECU ASSEMBLY. Refer to  REMOVAL [10/2014 - 05/2019] 

    Result: 

    NG 

    REPAIR OR REPLACE REPAIR OR REPLACE HARNESS OR CONNECTOR OR ECU