Removal [10/2014 - 09/2017]: Procedure
- DISABLE AUTOAWAY/RETURN FUNCTION
- Disable the autoaway/return function by changing the customize parameter.
Refer to CUSTOMIZE PARAMETERS [10/2014 - ]
WARNING:Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
HINT:
Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.
- Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
- Turn the power switch off.
- Disable the autoaway/return function by changing the customize parameter.
- REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY
Refer to PROCEDURE - Step 2 [10/2014 - 09/2015], or refer to PROCEDURE - Step 2 [09/2015 - 09/2017]
- REMOVE REAR DECK FLOOR BOX
Refer to PROCEDURE - Step 3 [10/2014 - 09/2015], or refer to PROCEDURE - Step 3 [09/2015 - 09/2017]
- REMOVE DECK FLOOR BOX LH
Refer to PROCEDURE - Step 4 [10/2014 - 09/2015], or refer to PROCEDURE - Step 4 [09/2015 - 09/2017]
- PRECAUTION NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work.
Refer to PRECAUTION [10/2014 - 09/2016] , or refer to PRECAUTION [09/2016 - 09/2017]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2014 - 09/2017]
- REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to REMOVAL [10/2014 - 09/2017]
- REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
- REMOVE COMBINATION METER MIRROR ECU (HEADUP DISPLAY)