LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> NX 200t Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission (U661E) - Diagnostic Codes (2 Of 2) & Circuit Tests) >> Automatic Transaxle System >> DTC U0100-87: Lost Communication with ECM/PCM "A" Missing Message [10/2014 - 05/2018] >> Description

DTC U0100-87: Lost Communication with ECM/PCM "A" Missing Message [10/2014 - 05/2018]: Description

WARNING: This page is about a different variant/trim than selected.

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN).

If there is a problem in this intercommunication, the ECM stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U0100-87 Lost Communication with ECM/PCM "A" Missing Message All conditions are met for 1.25 sec. or more (1-trip detection logic):
  • Engine switch on (IG)
  • Battery voltage is 9.5 V or higher
  • No intercommunication between engine control unit and transmission control unit
ECM Comes on DTC stored SAE: U0100