LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2015 >> NX 200t Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission (U661E) - Diagnostic Codes (2 Of 2) & Circuit Tests) >> Automatic Transaxle System >> DTC P2807-7F: Pressure Control Solenoid "G" Actuator Stuck Off [10/2014 - ] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
ALL

The monitor will run whenever the following DTCs are not stored. P0712, P0713 (TFT (ATF temperature) sensor circuit)
P0115, P0117, P0118 (ECT (Engine coolant temperature) sensor circuit)
P0717, P07BF, P07C0 (Turbine speed sensor circuit)
P0791, P0793 (Intermediate shaft speed sensor circuit)
P0748 (Shift solenoid valve SL1 circuit)
P0778 (Shift solenoid valve SL2 circuit)
P0798 (Shift solenoid valve SL3 circuit)
P2810 (Shift solenoid valve SL4 circuit)
P0327, P0328, P0332, P0333 (KCS (Knock control sensor) circuit)
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060B, P060D, P060E, P0657, P1607, P2102, P2103, P2111, P2112, P2118, P2119, P2135 (ETCS (Electronic throttle control system))
U0100 (CAN communication system)
TFT (ATF temperature) sensor circuit Not circuit malfunction
ECT (Engine coolant temperature) sensor circuit Not circuit malfunction
Turbine speed sensor circuit Not circuit malfunction
Intermediate shaft speed sensor circuit Not circuit malfunction
Shift solenoid valve SL1 circuit Not circuit malfunction
Shift solenoid valve SL2 circuit Not circuit malfunction
Shift solenoid valve SL3 circuit Not circuit malfunction
Shift solenoid valve SL4 circuit Not circuit malfunction
KCS (Knock control sensor) circuit Not circuit malfunction
ETCS (Electronic throttle control system) Not system down
CAN communication system Not system down
Transmission range "D"
Duration time from shifting "N" to "D" 4 sec. or more
TFT (ATF temperature) -10°C (14°F) or higher
Engine Starting
OFF MALFUNCTION (A)

ECM select gear 3rd
ECM indicated pressure value of SL1 1200 kPa (12.2 kgf/cm2 , 174 psi)
ECM indicated pressure value of SL2 0 kPa (0 kgf/cm2 , 0 psi)
ECM indicated pressure value of SL4 1200 kPa (12.2 kgf/cm2 , 174 psi)
Throttle valve opening angle 3% or more
OFF MALFUNCTION (B)

ECM select gear 5th
ECM indicated pressure value of SL1 0 kPa (0 kgf/cm2 , 0 psi)
ECM indicated pressure value of SL2 1200 kPa (12.2 kgf/cm2 , 174 psi)
ECM indicated pressure value of SL4 1200 kPa (12.2 kgf/cm2 , 174 psi)
Throttle valve opening angle 3% or more
OFF MALFUNCTION (C)

ECM select gear 3rd
Vehicle speed 2 km/h (1.2 mph) or more
Throttle valve opening angle 4.5% or more at engine speed of 2000 rpm
(Condition varies with engine speed)
ECT (Engine coolant temperature) 40°C (104°F) or higher
Turbine speed / Output speed (NT / NO) in 1st gear 3.304 to 7.724
Turbine speed / Output speed (NT / NO) in 2nd gear 1.901 to 2.340
Turbine speed / Output speed (NT / NO) in 3rd gear 1.399 to 1.649
Turbine speed / Output speed (NT / NO) in 4th gear 0.998 to 1.138
Turbine speed / Output speed (NT / NO) in 5th gear 0.705 to 0.836
Turbine speed / Output speed (NT / NO) in 6th gear 0.568 to 0.695
ON MALFUNCTION (A)

ECM select gear 1st
Time after transition to 1st gear 0.1 sec. or more
Vehicle speed 2 km/h (1.2 mph) to 40 km/h (24.9 mph)
Engine speed - Turbine speed 50 rpm or more
ECT (Engine coolant temperature) 40°C (104°F) or higher
Turbine speed / Output speed (NT / NO) in 1st gear 3.304 to 7.724
Turbine speed / Output speed (NT / NO) in 2nd gear 1.901 to 2.340
Turbine speed / Output speed (NT / NO) in 3rd gear 1.399 to 1.649
Turbine speed / Output speed (NT / NO) in 4th gear 0.998 to 1.138
Turbine speed / Output speed (NT / NO) in 5th gear 0.705 to 0.836
Turbine speed / Output speed (NT / NO) in 6th gear 0.568 to 0.695
ON MALFUNCTION (B)

ECM select gear 2nd
Time after transition to 2nd gear 0.1 sec. or more
Vehicle speed 2 km/h (1.2 mph) or more
Throttle valve opening angle 4.5% or more at engine speed 2000 rpm
(Condition varies with engine speed)
ECT (Engine coolant temperature) 40°C (104°F) or higher
Turbine speed / Output speed (NT / NO) in 1st gear 3.304 to 7.724
Turbine speed / Output speed (NT / NO) in 2nd gear 1.901 to 2.340
Turbine speed / Output speed (NT / NO) in 3rd gear 1.399 to 1.649
Turbine speed / Output speed (NT / NO) in 4th gear 0.998 to 1.138
Turbine speed / Output speed (NT / NO) in 5th gear 0.705 to 0.836
Turbine speed / Output speed (NT / NO) in 6th gear 0.568 to 0.695
ON MALFUNCTION (C)

ECM select gear 6th
Time after transition to 6th gear 0.1 sec. or more
Vehicle speed 2 km/h (1.2 mph) or more
Throttle valve opening angle 4.5% or more at engine speed 2000 rpm
(Condition varies with engine speed)
ECT (Engine coolant temperature) 40°C (104°F) or higher
Turbine speed / Output speed (NT / NO) in 1st gear 3.304 to 7.724
Turbine speed / Output speed (NT / NO) in 2nd gear 1.901 to 2.340
Turbine speed / Output speed (NT / NO) in 3rd gear 1.399 to 1.649
Turbine speed / Output speed (NT / NO) in 4th gear 0.998 to 1.138
Turbine speed / Output speed (NT / NO) in 5th gear 0.705 to 0.836
Turbine speed / Output speed (NT / NO) in 6th gear 0.568 to 0.695
ON MALFUNCTION (D)

ECM select gear 4th
Time after transition to 4th gear 0.1 sec. or more
Vehicle speed 2 km/h (1.2 mph) or more
Throttle valve opening angle 4.5% or more at engine speed 2000 rpm
(Condition varies with engine speed)
ECT (Engine coolant temperature) 40°C (104°F) or higher
Turbine speed / Output speed (NT / NO) in 1st gear 3.304 to 7.724
Turbine speed / Output speed (NT / NO) in 2nd gear 1.901 to 2.340
Turbine speed / Output speed (NT / NO) in 3rd gear 1.399 to 1.649
Turbine speed / Output speed (NT / NO) in 4th gear 0.998 to 1.138
Turbine speed / Output speed (NT / NO) in 5th gear 0.705 to 0.836
Turbine speed / Output speed (NT / NO) in 6th gear 0.568 to 0.695