DTC P2756-7F: Torque Converter Clutch Pressure Control Solenoid Control Actuator Stuck Off [10/2014 - 07/2020]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Transmission / Trouble Codes.

   Powertrain > Transmission > Trouble Codes 

5. Read the DTCs using the Techstream.

   Result

   Result	Proceed to
   Only DTC P2756-7F is output	A
   P2756-7F and other DTCs are output	B

   HINT: 

   If any DTCs other than P2756-7F are output, perform troubleshooting for those DTCs first.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2014 - 09/2015]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2015 - 09/2016]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2016 - 09/2017]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2017 - 05/2018]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [05/2018 - 05/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [05/2019 - 07/2020] 

Result: 

A 

See step  2

1. Remove shift solenoid valve SLU.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Shift Solenoid Valve SLU

   Refer to DISASSEMBLY [10/2014 - ]

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 - 2	20°C (68°F)	5.0 to 5.6 Ω

3. Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.

   OK

   Measurement Condition	Specified Condition
   Battery positive (+) with a 21 W bulb → Terminal 1 Battery negative (-) → Terminal 2	Valve moves and makes an operating noise

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE SHIFT SOLENOID VALVE SLU. Refer to  DISASSEMBLY [10/2014 - ] 

Result: 

OK 

See step  3

1. Check the transmission valve body assembly.

   Refer to REMOVAL [10/2014 - ]

   OK

   There is no foreign matter on each valve and they operate smoothly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE TRANSMISSION VALVE BODY ASSEMBLY. Refer to  REMOVAL [10/2014 - ] 

Result: 

OK 

See step  4

1. Check the torque converter assembly.

   Refer to INSPECTION [10/2014 - ]

   OK

   The torque converter clutch operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE AUTOMATIC TRANSAXLE ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2015]  , or refer to  REMOVAL [09/2015 - 05/2019]  , or refer to  REMOVAL [05/2019 - ] 

Result: 

NG 

REPLACE TORQUE CONVERTER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2015]  , or refer to  REMOVAL [09/2015 - 05/2019]  , or refer to  REMOVAL [05/2019 - ]